Read and understand all instructions and warnings before operating or using this product.This product is only intended and only safe for transporting
USE THESE HOLES FOR DESIRED LENGTH8'5'6'7'Front Pivot ArmRear Pivot ArmSTEP 11Determine the length of rack you need.FRONT TO REAR
VEHICLE MOUNTING PROCEDURE11
Unit will need to be placed on roof in aposition where the handle will be be-tween 3" - 6" behind van. There are afew preliminary steps you
STEP 18Determine what small hole to mount FrontRotation with after lining Mounting Base upwith Roof Ribs toward front of van. AttachFront Rotation Ass
STEP 20 (4 Places)With unit centered side to side, mark the holes in the Mountingbase (A). Move the unit out of the way enough to drill the 5/16"
FINAL ASSEMBLY15
16STEP 24With the side of the ladder sitting on theladder support of the rear slide downassembly in the up position, adjust theladder stop so that it
Product fits based on vehicle design available at the revision date. Vehicle manufacturers may change specs after the revision date, so if you have a
Front Cross-Member AssemblyQty. 1Rear Cross-Member AssemblyQty. 1Driveshaft/Handle AssemblyQty. 1Lower Handle SectionQty. 1Upper Handle SectionQty. 1C
FASTENER CHART5/16-18 x 4-1/2" Hex Hd. Bolt3/8-16 x 2-1/4" Hex Hd. Bolt5/16-18 x 2-3/4" Hex Hd. Bolt5/16-18 x 4" Hex Hd. Bolt5/16-
REAR ROTATION ASSEMBLY4
STEP 1Slide a White Plastic Bushing (A)into the Pivot Arm (B) as shown.(A)(B)STEP 2Use the supplied lubricant and coat the pre-assembledBlack Plastic
FRONT ROTATION ASSEMBLY76
STEP 4Slide a White Plastic Bushing (A)into the Pivot Arm (B) as shown.(A)(B)STEP 5Use the supplied lubricant and coat the pre-assembledBlack Plastic
STEP 7Place the Ladder Support (A) on top ofthe Connecting Tube (B) and install the5/16-18 x 2-3/4" Fastener.(A)(B)5/16-18 x 2-3/4"Hex Hd. B
Cotter PinClevis PinNOTE: Turn the Flow Controlcounter clockwise to releasepressure. Adjust Flow Con-trol Screw Per Instruction De-cal On Handle Tube
Kommentare zu diesen Handbüchern